Pitot Tubes and Annubars

These devices are used for larger pipe sizes when the fluid (gas, steam or liquid) is clean.

For a pitot tube, the difference between the total (stagnation) pressure at the tip of the pitot tube and the static pressure outside the pitot tube follows the square-root relationship. Flow rates are thus measured.

An annubar is a multiple-ported pitot tube that attempts to provide the average velocity.

A typical pitot tube is shown in Figure 500-12. Figure 500-13 is a schematic of an annubar.

Pitot Tube

Annubar Piping Requirements


Categories: Flow Measurement | Comments Off on Pitot Tubes and Annubars